Cisco ONS 15454 SDH - Table

21-41
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D465 Create FC_MR-4 RMON Alarm Thresholds
Step 6 From the Variable drop-down list, choose the variable. See Table 21-3 for a list of the FC_MR-4
threshold variables available in this field in line rate mode. See Table 21-4 for a list of the FC_MR-4
threshold variables available in this fields in enhanced mode.
Table 21-3 FC_MR-4 Threshold Variables for Fibre Channel/FICON Line Rate Mode
(MIBs)
Variable Definition
iflnOctets Total number of octets received on the interface, including
framing octets.
ifInDiscards The number of inbound packets that were chosen to be discarded
even though no errors had been detected to prevent their being
deliverable to a higher-layer protocol.
iflnErrors Number of inbound packets discarded because they contain
errors.
ifOutOctets Total number of transmitted octets, including framing packets.
ifOutDiscards The number of outbound packets that were chosen to be discarded
even though no errors had been detected to prevent their being
transmitted.
txTotalPkts Total number of transmit packets.
rxTotalPkts Total number of receive packets.
fibreStatsInvalidOrderedSets Received ordered sets that are not recognized as part of the
defined Fibre Channel control words.
fibreStatsEncodingDispErrors Received control words that cannot be decoded due to invalid
disparity.
fibreStatsRxFramesTooLong Received oversize Fibre Channel frames > 2148 including cyclic
redundancy check (CRC).
fibreStatsRxFramesBadCRC Received Fibre Channel frames with bad CRC.
fibreStatsRxFrames Received total Fibre Channel frames.
fibreStatsRxOctets Received total Fibre Channel data bytes within a frame.
fibreStatsTxFramesBadCRC Transmitted Fibre Channel frames with bad CRC.
fibreStatsTxFrames Transmitted total Fibre Channel frames.
fibreStatsTxOctets Transmitted total Fibre Channel data bytes within a frame.
fibreStatsLinkResets Total number of link resets initiated by FCMR port when link
recovery port setting is enabled.
gfpStatsRxSBitErrors Received generic framing protocol (GFP) frames with single bit
errors in the core header (these errors are correctable).
gfpStatsRxMBitErrors Received GFP frames with multiple bit errors in the core header
(these errors are not correctable).
gfpStatsRxTypeInvalid Received GFP frames with invalid type (these are discarded). For
example, receiving GFP frames that contain Ethernet data when
Fibre Channel data is expected.
gfpStatsRxSblkCRCErrors Total number of superblock CRC errors with the receive
transparent GFP frame. A transparent GFP frame has multiple
superblocks that each contain Fibre Channel data.