13-3
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 13 Convert Network Configurations
NTP- D338 Convert a Point-to-Point to a Linear ADM Automatically
Note If you are attempting to add an unreachable node you must first log in to the unreachable node
using a separate CTC session and configure that node. Delete any existing protection groups as
described in the “DLP-D155 Delete a Protection Group” task on page 18-47. Delete any existing
SDH DCC terminations as described in the “DLP-D360 Delete a Regenerator-Section DCC
Termination” task on page 20-66.
Step 6 Enter the node host name or IP address or choose the name of the new node from the drop-down list. If
you type in the name, make sure it is identical to the actual node name. The node name is case sensitive.
Step 7 When you have the name of the node in the menu, click Next. The Select Protection Group Ports page
appears (Figure 13-1).
Step 8 From the drop-down lists, select the working and protect ports on the new node that you want to connect
to each terminal node.
Figure 13-1 Selecting Protection Group Ports
Step 9
Click Next. The Re-fiber the Protected Path dialog box appears (Figure 13-2).
Figure 13-2 Refibering the Protect Path
Step 10 Follow the instructions on the page for connecting the fibers between the nodes.
To Next Page
Loading...
