11-3
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 11 Change Node Settings
NTP- D327 Modify OSI Provisioning
Step 3 Perform any of the following tasks as needed:
• DLP-D266 Change IP Settings, page 19-72
• DLP-D142 Modify a Static Route, page 18-34
• DLP-D143 Delete a Static Route, page 18-35
• DLP-D100 Delete a Proxy Tunnel, page 18-1
• DLP-D101 Delete a Firewall Tunnel, page 18-1
• DLP-D144 Disable OSPF, page 18-36
• DLP-D85 Lock Node Security, page 17-79
• DLP-D86 Modify MIC-C/T/P Port IP Settings, page 17-79
• DLP-D87 Disable Node Security Mode, page 17-80
Step 4 Complete the “NTP-D108 Back Up the Database” procedure on page 15-5.
Stop. You have completed this procedure.
NTP-D327 Modify OSI Provisioning
Note Additional information about the ONS 15454 implementation of OSI is provided in the “Management
Network Connectivity” chapter of the Cisco ONS 15454 SDH Reference Manual.
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49. If you are already logged in, continue with
Step 2.
Step 2 Complete the “NTP-D108 Back Up the Database” procedure on page 15-5.
Step 3 Perform any of the following tasks as needed:
• DLP-D166 Provision or Modify TARP Operating Parameters, page 18-55
• DLP-D167 Add a Static TID to NSAP Entry to the TARP Data Cache, page 18-57
• DLP-D168 Remove a Static TID to NSAP Entry from the TARP Data Cache, page 18-57
• DLP-D169 Add a TARP Manual Adjacency Table Entry, page 18-58
• DLP-D175 Remove a TARP Manual Adjacency Table Entry, page 18-63
• DLP-D178 Change the OSI Routing Mode, page 18-66
• DLP-D179 Edit the OSI Router Configuration, page 18-67
Purpose This procedure modifies the ONS 15454 OSI parameters including the OSI
routing mode, TARP, routers, subnets, and IP-over-CLNS tunnels.
Tools/Equipment None
Prerequisite Procedures NTP-D326 Provision OSI, page 4-14
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
