Cisco ONS 15454 SDH - DLP- D461 View FC_MR-4 Utilization PM Parameters

21-38
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D461 View FC_MR-4 Utilization PM Parameters
DLP-D461 View FC_MR-4 Utilization PM Parameters
Step 1 In node view, double-click the FC_MR-4 card where you want to view PM counts. The card view
appears.
Step 2 Click the Performance > Utilization tabs (Figure 21-12).
Figure 21-12 FC_MR-4 Utilization in the Card View Performance Window
Step 3
Click Refresh. Performance monitoring utilization values for each port on the card appear.
Step 4 View the port number column to find the port you want to monitor.
Step 5 The transmit (Tx) and receive (Rx) bandwidth utilization values for the previous time intervals appear
in the Prev-n columns. For PM parameter definitions, refer to the “Performance Monitoring” chapter in
the Cisco ONS 15454 SDH Reference Manual.
Step 6 Return to your originating procedure (NTP).
Purpose This task enables you to view line utilization PM counts on an FC_MR-4
card and port to detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
124916
Utilization
tab
Performance
tab
Card View
Refresh
button
Interval
drop-down list