21-9
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D426 Apply Alarm Profiles to Ports
d. Click Select to choose this name and location. Long file names are supported. CTC supplies a suffix
of *.pfl to stored files.
e. Click OK to store the profile.
Step 15 As needed, perform any of the following actions:
• Click the Hide Identical Rows check box to configure the Alarm Profiles window to view rows with
dissimilar severities.
• Click the Hide Reference Values check box to configure the Alarm Profiles window to view
severities that do not match the Default profile.
• Click the Only show service-affecting severities check box to configure the Alarm Profiles
window not to display minor and some major alarms that will not affect service.
Step 16 Return to your originating procedure (NTP).
DLP-D426 Apply Alarm Profiles to Ports
Step 1 In node view, double-click a card to open the card view.
Note You can also apply alarm profiles to cards using the “DLP-D117 Apply Alarm Profiles to Cards
and Nodes” task on page 18-18.
Step 2 Depending on which card you want to apply the profile to, click the following tabs:
• If the card is an FC_MR-4, E-Series Ethernet, G-Series Ethernet, STM-N, or electrical (DS3i-N-12,
E-1, E1-42, or E-3) card, click the Provisioning > Alarm Profiles > Alarm Profile Editor tabs.
• If the card is an ML-Series Ethernet (traffic) card, click the Provisioning > Ether Alarming >
Alarm Profile Editor tabs or the Provisioning > POS Alarming > Alarm Profile Editor tabs,
depending on whether you want to apply the profile to the front physical ports (“Ether alarming”)
or packet over SDH (“POS alarming”). For more information about ML-Series card ports and
service, see the Ethernet Card Software Feature and Configuration Guide for the Cisco ONS 15454,
Cisco ONS 15454 SDH, and Cisco ONS 15327.
Figure 21-4 shows the alarm profiles for an eight-port STM-1 card. CTC shows “Force all ports to
Profile: Inherited.”
Purpose This task applies a custom or default alarm severity profile to a port or
ports.
Tools/Equipment None
Prerequisite Procedures DLP-D425 Create a New or Cloned Alarm Severity Profile, page 21-6
DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
