Cisco ONS 15454 SDH - DLP- D336 Remove GBIC or SFP;XFP Device

20-32
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D336 Remove GBIC or SFP/XFP Device
b. Grip the sides of the GBIC with your thumb and forefinger and insert the GBIC into the slot on the
card.
c. Lock the GBIC into place by closing the handle down. The handle is in the correct closed position
when it does not obstruct access to an SC-type connector.
d. Slide the GBIC through the cover flap until you hear a click.
The click indicates the GBIC is locked into the slot.
e. When you are ready to attach the network fiber-optic cable, remove the protective plug from the
GBIC, save the plug for future use, and install the fiber connector.
f. Continue with Step 8.
Step 6 For SFPs/XFPs:
a. Plug the LC duplex connector of the fiber into a Cisco-supported SFP or XFP connector.
b. If the new SFP/XFP connector has a latch, close the latch over the cable to secure it.
c. Plug the cabled SFP/XFP connector into the card port until it clicks.
Step 7 Multirate SFPs on the MRC-12 card must be provisioned in CTC. If the SFP was not preprovisioned,
complete the “DLP-D132 Provision a Multirate PPM on the MRC-12 Card” task on page 18-27.
Step 8 Return to your originating procedure (NTP).
DLP-D336 Remove GBIC or SFP/XFP Device
Warning Class 1 laser product. Statement 1008
Warning Because invisible laser radiation may be emitted from the aperture of the port when no cable is
connected, avoid exposure to laser radiation and do not stare into open apertures. Statement 70
Step 1 Disconnect the network fiber cable from the GBIC SC connector or SFP/XFP LC duplex connector. If
the SFP/XFP connector has a latch securing the fiber cable, pull it upward to release the cable.
Step 2 If you are using a GBIC with clips:
a. Release the GBIC from the slot by simultaneously squeezing the two plastic tabs on each side of it.
b. Slide the GBIC or SFP/XFP out of the Gigabit Ethernet module slot. A flap closes over the GBIC
or SFP/XFP slot to protect the connector on the Gigabit Ethernet card.
Purpose This task disconnects fiber attached to GBICs or SFPs/XFPs.
Tools/Equipment None
Prerequisite Procedures DLP-D335 Install GBIC or SFP/XFP Devices, page 20-28
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None