8-5
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 8 Monitor Performance
NTP- D289 Create and Delete Ethernet RMON Thresholds
NTP-D289 Create and Delete Ethernet RMON Thresholds
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49. If you are already logged in, continue with
Step 2.
Step 2 Perform any of the following tasks as needed:
• DLP-D441 Create Ethernet RMON Alarm Thresholds, page 21-28
• DLP-D436 Delete Ethernet RMON Alarm Thresholds, page 21-25
Stop. You have completed this procedure.
NTP-D254 Monitor STM-N Performance
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the node that you want to monitor. If you
are already logged in, continue with Step 2.
Step 2 Complete the “DLP-D121 Enable Pointer Justification Count Performance Monitoring” task on
page 18-19 as needed to enable or disable clock synchronization monitoring.
Step 3 Complete the “DLP-D122 Enable Intermediate Path Performance Monitoring” task on page 18-21 as
needed to enable or disable monitoring of VC4 traffic through intermediate nodes.
Step 4 Complete the “DLP-D421 View STM-N PM Parameters” task on page 21-2.
Purpose This procedure creates or deletes Ethernet remote monitoring (RMON)
thresholds for the ONS 15454 SDH.
Tools/Equipment None
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This procedure enables you to view node near-end or far-end
performance during selected time intervals on an STM-N card and port
to detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see Chapter 6, “Create Circuits
and Low-Order Tunnels” and Chapter 10, “Change Card Settings.”
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
