21-2
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D421 View STM-N PM Parameters
Caution If you delete the Java policy file, you cannot log into nodes running Software R4.0 and earlier. If you
delete the file and want to log into an ONS 15454 SDH running an earlier release, insert the software
CD for the release into your PC CD-ROM and run the CTC setup wizard to reinstall the Java policy file.
Step 3 Return to your originating procedure (NTP).
DLP-D421 View STM-N PM Parameters
Step 1 In node view, double-click the STM-N card where you want to view PM counts. The card view appears.
Step 2 Click the Performance tab (Figure 21-1).
Purpose This task enables you to view performance monitoring (PM) counts on
an STM-N card and port to detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
