Cisco ONS 15454 SDH - Page 769

21-3
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D421 View STM-N PM Parameters
Figure 21-1 Viewing STM-N Card Performance Monitoring Information
Step 3
From the Line drop-down list, choose the line you want to monitor.
Step 4 Click Refresh.
Step 5 View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Curr (current), and Prev-n (previous) columns. For PM parameter definitions, refer to the “Performance
Monitoring” chapter in the Cisco ONS 15454 SDH Reference Manual.
Step 6 To monitor another port on a multiport card, choose another line from the Line drop-down list and click
Refresh.
Step 7 Return to your originating procedure (NTP).
102020
Directions
radio buttons
Performance
tab
Card View
Intervals
radio buttons
Auto-refreshRefresh
button
Port/Line Baseline
button
Clear
button