18-17
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D114 View Conditions
Figure 18-5 Node View Conditions Window
Conditions include all fault conditions raised on the node, whether or not they are reported.
Note Alarms can be unreported when they are filtered out of the display. See the “DLP-D227 Disable
Alarm Filtering” task on page 19-25 for information.
Events that are reported as Major (MJ), Minor (MN), or Critical (CR) severities are alarms. Events that
are reported as Not Alarmed (NA) are conditions. Conditions that are not reported at all are marked NR
in the Conditions window severity column.
Conditions that have a default severity of CR, MJ, MN, or NA but are not reported due to exclusion or
suppression are shown as NR in the Conditions window.
Current conditions are shown with the severity chosen in the alarm profile, if used. For more information
about alarm profiles, see the “NTP-D71 Create, Download, and Assign Alarm Severity Profiles”
procedure on page 9-6.
Note When a port is placed in the Locked-enabled,maintenance service state, it raises an Alarms
Suppressed for Maintenance (AS-MT) condition. For information about alarm and condition
troubleshooting, refer to the Cisco ONS 15454 SDH Troubleshooting Guide.
Note When a port is placed in the Unlocked-disabled,automaticInService service state but is not
connected to a valid signal, it generates a loss of signal (LOS) alarm.
Step 3 If you want to apply exclusion rules, check the Exclude Same Root Cause check box at the node or
network view, but do not check the Exclude Same Root Cause check box in card view.
To Next Page
Loading...
