Cisco ONS 15454 SDH - Terminal Loopbacks

Contents
v
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
NTP- D34 Set Up SNMP 4-12
NTP- D326 Provision OSI 4-14
CHAPTER 5 Turn Up a Network 5-1
Before You Begin 5-1
NTP- D35 Verify Node Turn-Up 5-2
NTP- D124 Provision a Point-to-Point Network 5-3
NTP- D339 Point-to-Point Network Acceptance Test 5-4
NTP- D38 Provision a Linear ADM Network 5-7
NTP- D340 Linear ADM Network Acceptance Test 5-8
NTP- D40 Provision MS-SPRing Nodes 5-10
NTP- D41 Create the MS-SPRing 5-13
NTP- D341 Two-Fiber MS-SPRing Acceptance Test 5-14
NTP- D342 Four-Fiber MS-SPRing Acceptance Test 5-16
NTP- D304 Provision a Traditional MS-SPRing Dual-Ring Interconnect 5-18
NTP- D305 Provision an Integrated MS-SPRing Dual-Ring Interconnect 5-21
NTP- D44 Provision SNCP Nodes 5-22
NTP- D343 SNCP Acceptance Test 5-24
NTP- D217 Provision a Traditional SNCP Dual-Ring Interconnect 5-26
NTP- D218 Provision an Integrated SNCP Dual-Ring Interconnect 5-28
NTP- D306 Provision a Traditional MS-SPRing/SNCP Dual-Ring Interconnect 5-30
NTP- D307 Provision an Integrated MS-SPRing/SNCP Dual-Ring Interconnect 5-32
NTP- D258 Provision an Open-Ended SNCP 5-34
NTP- D344 Open-Ended SNCP Acceptance Test 5-36
NTP- D46 Subtend an SNCP from an MS-SPRing 5-39
NTP- D47 Subtend an MS-SPRing from an SNCP 5-40
NTP- D48 Subtend an MS-SPRing from an MS-SPRing 5-41
NTP- D172 Create a Logical Network Map 5-43
CHAPTER 6 Create Circuits and Low-Order Tunnels 6-1
Before You Begin 6-1
NTP- D127 Verify Network Turn-Up 6-5
NTP- D334 Create an Automatically Routed Low-Order VC11 Circuit 6-7
NTP- D335 Create a Manually Routed Low-Order VC11 Circuit 6-12
NTP- D336 Create a Unidirectional Low-Order VC11 Circuit with Multiple Drops 6-15
NTP- D81 Create an Automatically Routed Low-Order VC12 Circuit 6-19