Cisco ONS 15454 SDH - Page 6

Contents
vi
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
NTP- D82 Create a Manually Routed Low-Order VC12 Circuit 6-24
NTP- D83 Create a Unidirectional Low-Order VC12 Circuit with Multiple Drops 6-27
NTP- D54 Create an Automatically Routed Low-Order VC3 Circuit 6-31
NTP- D55 Create a Manually Routed Low-Order VC3 Circuit 6-35
NTP- D56 Create a Unidirectional Low-Order VC3 Circuit with Multiple Drops 6-38
NTP- D133 Create an Automatically Routed Low-Order Tunnel 6-42
NTP- D134 Create a Manually Routed Low-Order Tunnel 6-45
NTP- D216 Create a Low-Order Path Tunnel for Port Grouping 6-47
NTP- D187 Create a Low-Order Aggregation Point 6-50
NTP- D135 Test Low-Order Circuits 6-53
NTP- D323 Create an Automatically Routed High-Order Circuit 6-55
NTP- D324 Create a Manually Routed High-Order Circuit 6-60
NTP- D190 Create a Unidirectional High-Order Circuit with Multiple Drops 6-63
NTP- D62 Test High-Order Circuits 6-66
NTP- D139 Create a Half Circuit on an MS-SPRing or 1+1 Node 6-68
NTP- D140 Create a Half Circuit on an SNCP Ring Node 6-70
NTP- D191 Create an E-Series EtherSwitch Circuit (Multicard or Single-Card Mode) 6-72
NTP- D192 Create a Circuit for an E-Series Card in Port-Mapped Mode 6-75
NTP- D142 Create an E-Series Shared Packet Ring Ethernet Circuit 6-77
NTP- D143 Create an E-Series Hub-and-Spoke Ethernet Configuration 6-80
NTP- D144 Create an E-Series Single-Card EtherSwitch Manual Cross-Connect 6-82
NTP- D145 Create an E-Series Multicard EtherSwitch Manual Cross-Connect 6-85
NTP- D146 Test E-Series Circuits 6-89
NTP- D148 Create a Manual Cross-Connect for a G-Series or E-Series Card in Port-Mapped Mode 6-90
NTP- D241 Provision G-Series Ports for Transponder Mode 6-92
NTP- D149 Test G-Series Circuits 6-95
NTP- D194 Create Overhead Circuits 6-96
NTP- D283 Create an Automatically Routed VCAT Circuit 6-97
NTP- D284 Create a Manually Routed VCAT Circuit 6-101
NTP- D325 Create an STM Test Circuit around the Ring 6-103
NTP- D350 Create a Server Trail 6-106
CHAPTER 7 Manage Circuits 7-1
Before You Begin 7-1
NTP- D199 Locate and View Circuits 7-2
NTP- D200 View Cross-Connect Card Resource Usage 7-2