7-2
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 7 Manage Circuits
NTP- D199 Locate and View Circuits
NTP-D199 Locate and View Circuits
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at a node on the network where you want
to view the circuits. If you are already logged in, continue with Step 2.
Do not check the Disable Circuit Management check box in the Login dialog box. No circuits appear if
this option is checked.
Step 2 As needed, complete the “DLP-D370 View Circuit Information” task on page 20-76.
Step 3 As needed, complete the “DLP-D131 Search for Circuits” task on page 18-26.
Step 4 As needed, complete the “DLP-D262 Filter the Display of Circuits” task on page 19-65.
Step 5 As needed, complete the “DLP-D229 View Circuits on a Span” task on page 19-25.
Step 6 As needed, complete the “DLP-D371 View the MS-SPRing Squelch Table” task on page 20-80.
Step 7 As needed, complete the “DLP-D23 View Spanning Tree Information” task on page 17-19.
Step 8 As needed, complete the “DLP-D147 Export CTC Data” task on page 18-38.
Stop. You have completed this procedure.
NTP-D200 View Cross-Connect Card Resource Usage
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the node where you want to view the
cross-connect card resource usage. If you are already logged in, continue with Step 2.
Step 2 Click the Maintenance > Cross-Connect > Resource Usage tabs.
Purpose This procedure allows you to locate and view circuits and E-Series
Ethernet card spanning tree information. You can also export circuit data
from the Circuits and Edit Circuits windows.
Tools/Equipment None
Prerequisite Procedures Circuit creation procedures in Chapter 6, “Create Circuits and Low-Order
Tunnels.”
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
Purpose This procedure provides the percentage of cross-connect card resources
used by circuits that traverse or terminate at an ONS 15454 SDH.
Tools/Equipment XC-VXL-10G, XC-VXL-2.5G, or XC-VXC-10G cards must be installed.
Prerequisite Procedures DLP-D333 Install the XC-VXL-10G, XC-VXL-2.5G, or XC-VXC-10G
Cards, page 20-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
