Contents
vii
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
NTP- D287 Modify and Delete Circuits 7-4
NTP- D288 Modify and Delete Overhead Circuits and Server Trails 7-4
NTP- D78 Create a Monitor Circuit 7-5
NTP- D329 Create a J0 Section Trace 7-6
NTP- D79 Create a J1 or J2 Path Trace 7-8
NTP- D332 Bridge and Roll Traffic 7-9
NTP- D309 Reconfigure Circuits 7-10
NTP- D310 Merge Circuits 7-11
NTP- D352 Manage VLANs 7-11
CHAPTER
8 Monitor Performance 8-1
Before You Begin 8-1
NTP- D257 Change the PM Display 8-2
NTP- D195 Monitor Electrical Performance 8-3
NTP- D198 Monitor Ethernet Performance 8-4
NTP- D289 Create and Delete Ethernet RMON Thresholds 8-5
NTP- D254 Monitor STM-N Performance 8-5
NTP- D301 Monitor FC_MR-4 Performance 8-6
NTP- D302 Create or Delete FC_MR-4 RMON Thresholds 8-6
CHAPTER
9 Manage Alarms 9-1
Before You Begin 9-1
NTP- D195 Document Existing Provisioning 9-2
NTP- D196 View Alarms, History, Events, and Conditions 9-2
NTP- D68 Delete Cleared Alarms from Display 9-3
NTP- D69 View Alarm-Affected Circuits 9-4
NTP- D70 View Alarm Counts on the LCD for a Node, Slot, or Port 9-5
NTP- D71 Create, Download, and Assign Alarm Severity Profiles 9-6
NTP- D168 Enable, Modify, or Disable Alarm Severity Filtering 9-7
NTP- D72 Suppress Alarms or Discontinue Alarm Suppression 9-7
NTP- D247 Provision External Alarms and Controls on the Alarm Interface Controller–International 9-8
CHAPTER
10 Change Card Settings 10-1
Before You Begin 10-1
NTP- D88 Modify Line Settings and PM Parameter Thresholds for Electrical Cards 10-2
NTP- D89 Modify Line Settings and PM Parameter Thresholds for Optical Cards 10-2
To Next Page
Loading...
