Contents
viii
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
NTP- D118 Modify Alarm Interface Controller–International Settings 10-3
NTP- D91 Upgrade E1-N-14 and DS3 i-N-12 Protect Cards from 1:1 Protection to 1:N Protection 10-4
NTP- D311 Modify Port Settings and PM Parameter Thresholds for SAN Cards 10-5
NTP- D330 Change Card or PPM Service State 10-5
NTP- D331 Manage Pluggable Port Modules 10-6
CHAPTER
11 Change Node Settings 11-1
Before You Begin 11-1
NTP- D81 Change Node Management Information 11-2
NTP- D201 Change CTC Network Access 11-2
NTP- D327 Modify OSI Provisioning 11-3
NTP- D202 Customize the CTC Network View 11-4
NTP- D203 Modify or Delete Card Protection Settings 11-5
NTP- D277 Modify or Delete Communications Channel Terminations and Provisionable Patchcords 11-5
NTP- D85 Change Node Timing 11-6
NTP- D205 Modify Users and Change Security 11-7
NTP- D87 Change SNMP Settings 11-7
CHAPTER
12 Upgrade Cards and Spans 12-1
Before You Begin 12-1
NTP- D234 Upgrade the XC-VXL-2.5G Card to the XC-VXL-10G or XC-VXC-10G Card 12-2
NTP- D333 Upgrade the XC-VXL-10G Card to the XC-VXC-10G Card 12-4
NTP- D314 Upgrade the TCC2 Card to the TCC2P Card 12-5
NTP- D94 Upgrade STM-N Cards and Spans Automatically 12-7
NTP- D95 Upgrade Optical Spans Manually 12-10
NTP- D374 Upgrade STM-N Cards Manually 12-12
CHAPTER
13 Convert Network Configurations 13-1
Before You Begin 13-1
NTP- D338 Convert a Point-to-Point to a Linear ADM Automatically 13-2
NTP- D154 Convert a Point-to-Point to a Linear ADM Manually 13-4
NTP- D318 Convert an Unprotected Point-to-Point or Linear ADM to a Two-Fiber MS-SPRing
Automatically 13-6
NTP- D155 Convert a Point-to-Point or a Linear ADM to a Two-Fiber MS-SPRing Manually 13-8
NTP- D351 Convert a Point-to-Point or Linear ADM to an SNCP Automatically 13-10
NTP- D156 Convert a Point-to-Point or Linear ADM to an SNCP Manually 13-11
To Next Page
Loading...
