Contents
ix
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
NTP- D320 Convert an SNCP to a Two-Fiber MS-SPRing Automatically 13-12
NTP- D210 Convert an SNCP to a Two-Fiber MS-SPRing Manually 13-14
NTP- D211 Convert a Two-Fiber MS-SPRing to a Four-Fiber MS-SPRing Automatically 13-16
NTP- D159 Modify an MS-SPRing 13-18
CHAPTER
14 Add and Remove Nodes 14-1
Before You Begin 14-1
NTP- D353 Add an MS-SPRing Node 14-2
NTP- D213 Remove an MS-SPRing Node 14-7
NTP- D105 Add an SNCP Node 14-10
NTP- D106 Remove an SNCP Node 14-12
NTP- D280 Add a Node to a Linear ADM Manually 14-14
NTP- D337 Add a Node to a Linear ADM Using the Wizard 14-15
NTP- D322 Remove an In-Service Node from a Linear ADM 14-18
CHAPTER
15 Maintain the Node 15-1
Before You Begin 15-1
NTP- D107 Inspect and Maintain the Air Filter 15-2
NTP- D108 Back Up the Database 15-5
NTP- D109 Restore the Database 15-6
NTP- D328 View and Manage OSI Information 15-8
NTP- D163 Restore the Node to Factory Configuration 15-9
NTP- D312 Viewing the Audit Trail Records 15-10
NTP- D214 Off-Load the Audit Trail Record 15-12
NTP- D313 Off-Load the Diagnostics File 15-13
NTP- D231 Initiate or Clear an External Switching Command 15-14
NTP- D112 Clean Fiber Connectors 15-15
NTP- D153 Reset a Card Using CTC 15-16
NTP- D215 View G-Series Ethernet Maintenance Information 15-16
NTP- D266 View E-Series Ethernet Maintenance Information 15-17
NTP- D233 Change the Node Timing Reference 15-18
NTP- D265 View the ONS 15454 SDH Timing Report 15-18
NTP- D229 Replace an In-Service Cross-Connect Card 15-21
NTP- D230 Replace the Fan-Tray Assembly 15-22
NTP- D345 Edit Network Element Defaults 15-25
NTP- D346 Import Network Element Defaults 15-26
To Next Page
Loading...
