Cisco ONS 15454 SDH - Perform a Facility (Line) Loopback on a Source Electrical Port (West to East)

Contents
x
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
NTP- D347 Export Network Element Defaults 15-27
CHAPTER 16 Power Down the Node 16-1
NTP- D114 Power Down the Node 16-1
CHAPTER 17 DLPs D1 to D99 17-1
DLP- D1 Unpack and Verify the Shelf Assembly 17-1
DLP- D2 Inspect the Shelf Assembly 17-2
DLP- D3 Provision a Low-Order VC12 Circuit Route 17-2
DLP- D4 Create an IP-Encapsulated Tunnel 17-3
DLP- D5 Mount the Shelf Assembly in a Rack (One Person) 17-4
DLP- D6 Mount the Shelf Assembly in a Rack (Two People) 17-6
DLP- D7 Mount Multiple Shelf Assemblies in a Rack 17-7
DLP- D8 Open the Front Cabinet Compartment (Door) 17-9
DLP- D9 Remove the Front Door 17-10
DLP- D14 Create a Four-Fiber MS-SPRing Using the MS-SPRing Wizard 17-11
DLP- D16 Connect the Office Ground to the ONS 15454 SDH 17-13
DLP- D17 Connect Office Power to the ONS 15454 SDH Shelf 17-15
DLP- D18 Turn On and Verify Office Power 17-16
DLP- D22 Install Fiber-Optic Cables in a 1+1 Configuration 17-17
DLP- D23 View Spanning Tree Information 17-19
DLP- D24 Change an MS-SPRing Node ID 17-19
DLP- D25 Configure the CTC Alerts Dialog Box for Automatic Popup 17-20
DLP- D26 Provision a VCAT Circuit Route 17-20
DLP- D27 Delete Circuits 17-21
DLP- D28 Create a Four-Fiber MS-SPRing Manually 17-22
DLP- D29 Change Tunnel Type 17-24
DLP- D30 Repair an IP Tunnel 17-25
DLP- D31 Delete Overhead Circuits 17-25
DLP- D32 Inspect the Shelf Installation and Connections 17-26
DLP- D33 Measure Voltage 17-26
DLP- D34 Delete VLANs 17-27
DLP- D35 Delete a Node from the Current Session or Login Group 17-27
DLP- D36 Provision a VCAT Circuit Source and Destination 17-28
DLP- D37 Reset a TCC2/TCC2P Card Using CTC 17-29
DLP- D38 Reset a Traffic Card in CTC 17-30
DLP- D39 Install Ethernet Cards 17-30
DLP- D40 Create a Provisionable Patchcord 17-31
DLP- D41 Delete a Provisionable Patchcord 17-33