Contents
xi
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
DLP- D42 Install Fiber-Optic Cables on an LGX Interface 17-33
DLP- D43 Initiate an Optical Protection Switch 17-34
DLP- D44 Initiate an Electrical Protection Switch 17-35
DLP- D45 Install the Fiber Boot 17-35
DLP- D50 Set Up a Windows PC for Craft Connection to an ONS 15454 SDH on the Same Subnet
Using Static IP Addresses 17-37
DLP- D51 Set Up a Windows PC for Craft Connection to an ONS 15454 SDH Using Dynamic Host
Configuration Protocol 17-39
DLP- D52 Set Up a Windows PC for Craft Connection to an ONS 15454 SDH Using Automatic Host
Detection 17-42
DLP- D53 Set Up a Solaris Workstation for a Craft Connection to an ONS 15454 SDH 17-45
DLP- D54 Delete a Node from a Specified Login Node Group 17-47
DLP- D56 Disable Proxy Service Using Internet Explorer (Windows) 17-47
DLP- D57 Disable Proxy Service Using Netscape (Windows and UNIX) 17-48
DLP- D60 Log into CTC 17-49
DLP- D61 Create Login Node Groups 17-51
DLP- D62 Add a Node to the Current Session or Login Group 17-53
DLP- D64 Set the IP Address, Default Router, and Network Mask Using the LCD 17-53
DLP- D65 Create a Static Route 17-56
DLP- D67 Provision the IIOP Listener Port on the ONS 15454 SDH 17-57
DLP- D68 Provision the IIOP Listener Port on the CTC Computer 17-57
DLP- D69 Set Up External or Line Timing 17-58
DLP- D70 Set Up Internal Timing 17-61
DLP- D71 Create a 1:1 Protection Group 17-62
DLP- D72 Create a 1:N Protection Group 17-63
DLP- D73 Create a 1+1 Protection Group 17-64
DLP- D74 Create a New User on a Single Node 17-65
DLP- D75 Create a New User on Multiple Nodes 17-66
DLP- D76 Add a Member to a VCAT Circuit 17-67
DLP- D77 Delete a Member from a VCAT Circuit 17-69
DLP- D78 Install the TL1 Craft Interface on the MIC-C/T/P 17-70
DLP- D79 Remove Pass-through Connections 17-71
DLP- D80 Change a VCAT Member Service State 17-72
DLP- D81 Provision a Proxy Tunnel 17-73
DLP- D82 View Alarms 17-74
DLP- D83 Provision Orderwire 17-76
DLP- D84 Enable Node Security Mode 17-77
DLP- D85 Lock Node Security 17-79
DLP- D86 Modify MIC-C/T/P Port IP Settings 17-79
DLP- D87 Disable Node Security Mode 17-80
To Next Page
Loading...
