Cisco ONS 15454 SDH - Optical Card Transmit and Receive Levels

5-13
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 5 Turn Up a Network
NTP- D41 Create the MS-SPRing
Step 10 Complete the “NTP-D41 Create the MS-SPRing” procedure on page 5-13.
Stop. You have completed this procedure.
NTP-D41 Create the MS-SPRing
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at a node on the network where you will
create the MS-SPRing.
Step 2 Complete one of the following tasks:
• DLP-D468 Create a Two-Fiber MS-SPRing Using the MS-SPRing Wizard, page 21-44–Use this
task to create a two-fiber MS-SPRing using the CTC MS-SPRing wizard. The MS-SPRing wizard
checks to see that each node is ready for MS-SPRing provisioning, then provisions all the nodes at
once. Using the MS-SPRing wizard is recommended.
• DLP-D14 Create a Four-Fiber MS-SPRing Using the MS-SPRing Wizard, page 17-11–Use this task
to create a four-fiber MS-SPRing using the CTC MS-SPRing wizard. The MS-SPRing wizard
checks to see that each node is ready for MS-SPRing provisioning, then provisions all the nodes at
once. Using the MS-SPRing wizard is recommended.
• DLP-D469 Create a Two-Fiber MS-SPRing Manually, page 21-46–Use this task to provision a
two-fiber MS-SPRing manually at each node that will be in the MS-SPRing.
• DLP-D28 Create a Four-Fiber MS-SPRing Manually, page 17-22–Use this task to provision a
four-fiber MS-SPRing manually at each node that will be in the MS-SPRing.
Step 3 Complete the “NTP-D341 Two-Fiber MS-SPRing Acceptance Test” procedure on page 5-14 or the
“NTP-D342 Four-Fiber MS-SPRing Acceptance Test” procedure on page 5-16.
Stop. You have completed this procedure.
Purpose This procedure creates an MS-SPRing at each MS-SPRing-provisioned
node.
Tools/Equipment None
Prerequisite Procedures NTP-D35 Verify Node Turn-Up, page 5-2
NTP-D40 Provision MS-SPRing Nodes, page 5-10
Required/As Needed As needed; required to complete MS-SPRing provisioning
Onsite/Remote Onsite or remote
Security Level Provisioning or higher