EasyManua.ls Logo

Cisco ONS 15454 SDH - Page 131

Cisco ONS 15454 SDH
860 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER
5-1
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
5
Turn Up a Network
This chapter explains how to turn up and test Cisco ONS 15454 SDH networks, including point-to-point
networks, linear add/drop multiplexers (ADMs), subnetwork connection protection rings (SNCPs), and
multiplex section-shared protection rings (MS-SPRings).
Before You Begin
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1. NTP-D35 Verify Node Turn-Up, page 5-2—Complete this procedure before beginning network
turn-up.
2. NTP-D124 Provision a Point-to-Point Network, page 5-3—Complete as needed.
3. NTP-D339 Point-to-Point Network Acceptance Test, page 5-4—Complete this procedure after you
create a point-to-point network.
4. NTP-D38 Provision a Linear ADM Network, page 5-7—Complete as needed.
5. NTP-D340 Linear ADM Network Acceptance Test, page 5-8—Complete this procedure after you
create a linear ADM.
6. NTP-D40 Provision MS-SPRing Nodes, page 5-10—Complete this procedure to provision
ONS 15454 SDHs in a two-fiber or four-fiber MS-SPRing.
7. NTP-D41 Create the MS-SPRing, page 5-13—Complete this procedure after provisioning the
MS-SPRing nodes.
8. NTP-D341 Two-Fiber MS-SPRing Acceptance Test, page 5-14—Complete this procedure after you
create a two-fiber MS-SPRing.
9. NTP-D342 Four-Fiber MS-SPRing Acceptance Test, page 5-16—Complete this procedure after you
create a four-fiber MS-SPRing.
10. NTP-D304 Provision a Traditional MS-SPRing Dual-Ring Interconnect, page 5-18—As needed,
complete this procedure after you provision a MS-SPRing.
11. NTP-D305 Provision an Integrated MS-SPRing Dual-Ring Interconnect, page 5-21—As needed,
complete this procedure after you provision a MS-SPRing.
12. NTP-D44 Provision SNCP Nodes, page 5-22—Complete as needed.
13. NTP-D343 SNCP Acceptance Test, page 5-24—Complete this procedure after you create an SNCP
ring.
14. NTP-D217 Provision a Traditional SNCP Dual-Ring Interconnect, page 5-26—As needed, complete
this procedure after you provision an SNCP ring.

Table of Contents

Other manuals for Cisco ONS 15454 SDH

Related product manuals