2-7
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 2 Install Cards and Fiber-Optic Cable
NTP- D16 Install STM-N Cards and Connectors
Step 5 Continue with the following procedures, as needed:
• NTP-D16 Install STM-N Cards and Connectors, page 2-7
• NTP-D17 Install the Electrical Cards, page 2-10
• NTP-D18 Install Ethernet Cards and Connectors, page 2-11
• NTP-D286 Install the FC_MR-4 Cards, page 2-12
Stop. You have completed this procedure.
NTP-D16 Install STM-N Cards and Connectors
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself.
Statement 94
OC192SR1/
STM64IO Short
Reach and
OC192/STM64
Any Reach
2
XX XX
FC_MR-4 XXXXXX XXXXXX
15454_MRC-12
3
XXXXXX XXXXXX
1. The term XC is used generically to mean cross-connect card.
2. Designated as STM64-XFP in CTC.
3. Designated as MRC-12 in CTC.
Table 2-2 Slot Compatibility for the XC-VXL-10G or XC-VXC-10G Card (continued)
Slot 1234567 89 1011 121314151617
Type MS MS MS MS MS MS
TCC2/
TCC2P XC
1
AIC-I XC
1
TCC2/
TCC2PMSMSMSMSMSMS
Purpose This procedure installs the optical cards (STM-1, STM1-8, STM-4,
STM4-4, STM-16, STM-64, and 15454_MRC-12). The MRC-12
(multirate), OC192SR1/STM64IO Short Reach (STM64-XFP Short
Reach), and OC192/STM64 Any Reach(STM64-XFP Any Reach) cards
require Small Form-factor Pluggables (SFPs/XFPs) to provide the fiber
interface to the cards. On all other optical cards, the fiber is plugged
directly into the card. Install according to site plan, if available.
Tools/Equipment STM-1, STM-4, STM-16, STM-64, and MRC-12 cards (as applicable)
Prerequisite Procedures NTP-D15 Install the Common Control Cards, page 2-2
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
