xv
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
About this Guide
Document Objectives
This guide provides procedures for installation, turn up, provisioning, and acceptance of
ONS 15454 SDH nodes and ONS 15454 SDH networks.
Audience
To use this publication, you should be familiar with Cisco or equivalent optical transmission hardware
and cabling, telecommunications hardware and cabling, electronic circuitry and wiring practices, and
preferably have experience as a telecommunications technician.
Document Organization
The organization of the guide reflects Cisco’s recommended work flow for new installations. This
organization also provides easy access to procedures and tasks used to modify existing installations.
Verification procedures are provided, where necessary, to allow contract vendors to complete the
physical installation and then turn over the site to craft personnel for verification, provisioning, turn-up,
and acceptance.
The front matter of the book appears in the following sequence:
1. Title Page
2. Table of Contents
3. List of Figures
4. List of Tables
5. List of Procedures
6. List of Tasks
January 2010
• Updated the section “NTP-D94 Upgrade STM-N Cards and Spans
Automatically” in the chapter Upgrade Cards and Spans.
• Updated the “Add an SNCP Node” procedure in Chapter 14, “Add and
Remove Node”.
November 2010 Added a note to DLP-D211 in the chapter, DLPs D200 to D299.
December 2011 Updated the procedure, “NTP-D94 Upgrade STM-N Cards and Spans
Automatically” in the chapter, “Upgrade Cards and Spans”.
May 2012
• Added a note to “NTP-D94 Upgrade OC-N Cards and Spans Automatically”
procedure in the chapter, “Upgrade Cards and Spans”.
• Added a new procedure “NTP-D374 Upgrade STM-N Cards Manually” to the
chapter, “Upgrade Cards and Spans”.
• Updated the procedure, “NTP-D34 Set Up SNMP” in the chapter, “Turn Up
a Node”.
August 2012 The full length book-PDF was generated.
Date Notes
To Next Page
Loading...
