18-10
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D108 Change Line Settings for STM-N Cards
Port Rate (Display only) (MRC-12 and STM64-XFP cards
only) Displays the port rate set for the PPM.
• STM-1
• STM-4
• STM-16
• STM-64 (STM64-XFP only)
SF BER Sets the signal fail bit error rate.
• 1E-3
• 1E-4
• 1E-5
SD BER Sets the signal degrade bit error rate.
• 1E-5
• 1E-6
• 1E-7
• 1E-8
• 1E-9
Provides
Synch
(Display only) If checked, the card is
provisioned as a network element (NE) timing
reference.
• Yes
• No
Send Do Not
Use
When checked, sends a do not use (DUS)
message on the S1 byte.
• Yes
• No
Synch
Message In
Enables synchronization status messages
(SSMs) (S1 byte), which allow the node to
choose the best timing source.
• Yes
• No
Send <FF>
DoNotUse
When checked, sends a special DUS (0xff)
message on the S1 byte.
• Yes
• No
Admin SSM In Overrides the synchronization traceability
unknown (STU) value (default setting). You
cannot select Admin SSM In if Sync Message In
is enabled on the STM-N card.
• G811
• G812T
• G812L
• SETS
• DUS
MS-SPRing
Ext. Byte
Allows you to change the multiplex
section-shared protection ring (MS-SPRing)
extension byte.
• K3
• Z2
• E2
• F1
PJVC4Mon # Sets the VC4 that will be used for pointer
justification. If set to 0, no VC4 is monitored.
Only one VC4 can be monitored on each STM-N
port.
• 0 - 1 (STM-1, per port)
• 0 - 4 (STM-4, per port)
• 0 - 16 (STM-16)
• 0 - 64 (STM-64)
Table 18-1 STM-N Card Line Settings (continued)
Parameter Description Options
To Next Page
Loading...
