6-107
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 6 Create Circuits and Low-Order Tunnels
NTP- D350 Create a Server Trail
d. As applicable, choose the following:
• From the VC4 drop-down list, choose the source VC4.
• From the TUG3 drop-down list, choose the source TUG3.
• From the TUG2 drop-down list, choose the source TUG2.
• From the VC11 drop-down list, choose the source VC11.
Step 8 Click Next.
Step 9 In the Destination area, complete the following:
a. From the Node drop-down list, choose the node where the source will terminate.
b. From the Slot drop-down list, choose the slot.
c. From the Port drop-down list, choose the port.
d. As applicable, choose the following:
• From the VC4 drop-down list, choose the source VC4.
• From the TUG3 drop-down list, choose the source TUG3.
• From the TUG2 drop-down list, choose the source TUG2.
• From the VC11 drop-down list, choose the source VC11.
Step 10 Click Finish.
Stop. You have completed this procedure.
To Next Page
Loading...
