EasyManua.ls Logo

Cisco ONS 15454 SDH - Page 336

Cisco ONS 15454 SDH
860 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12-8
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 12 Upgrade Cards and Spans
NTP- D94 Upgrade STM-N Cards and Spans Automatically
Note An STM-1 to eight-port STM-1 span upgrade, or an STM-4 to four-port STM-4 span upgrade can only
be performed from Slots 1 to 4 and 14 to 17, because the STM1-8 and STM4-4 card can only be installed
in these slots. Ensure that the STM-1 and STM-4 cards are in these slots before performing a span
upgrade to the STM1-8 and STM4-4. The four STM-1 ports will be sequentially mapped to Ports 1 to 4
on the eight-port STM-1 card. The STM-4 port will be mapped to Port 1 on the four-port STM-4 card.
Note The only cards that can be upgraded to a MRC-12 card are one-port STM-4 cards or one-port STM-16
cards. The port from the lower-speed card will be mapped to Port 1 on the MRC-12 card.
Note Before performing automatic Span Upgrade, make sure that the TCC card is not soft resetting or pulled
out and there are no fiber cuts or node power cycles.
Step 1 Determine the span upgrade you need to perform. Valid span upgrades include:
Four-port STM-1 to eight-port STM-1
Single-port STM-4 to four-port STM-4
Single-port STM-4 to STM-16
Single-port STM-4 to STM-64
Single-port STM-4 to MRC-12
Single-port STM-4 to STM-16 on MRC-12
STM-16 to STM-64
STM-16 to MRC-12
STM-16 to OC192SR1/STM64IO Short Reach or OC192/STM64 Any Reach
STM-64 to OC192SR1/STM64IO Short Reach or OC192/STM64 Any Reach
Note You cannot upgrade a four-port STM-4 span. If the ring contains any STM4-4 cards and you
want to upgrade the entire ring, you will have to downgrade the STM4-4 card to a single-port
STM-4 card (which is not possible unless only one port on the STM4-4 card is being used).
Note Do not upgrade an STM-16 to an STM-64 if you have XC-VXL-2.5Gs installed. The
XC-VXL-2.5G card works only with card speeds up to STM-16.
Valid card upgrades include:
Single-port STM-4 to STM-16
Single-port STM-4 to STM-16 on MRC-12
Single-port STM-4 to STM-64
Single-port STM-4 to MRC-12
STM-16 to STM-64
STM-16 to OC192SR1/STM64IO Short Reach or OC192/STM64 Any Reach

Table of Contents

Other manuals for Cisco ONS 15454 SDH

Related product manuals