Cisco ONS 15454 SDH - Page 34

Procedures
x
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
DLP-D43 Initiate an Optical Protection Switch 17-34
DLP-D44 Initiate an Electrical Protection Switch 17-35
DLP-D45 Install the Fiber Boot 17-35
DLP-D50 Set Up a Windows PC for Craft Connection to an ONS 15454 SDH on the Same Subnet Using Static
IP Addresses
17-37
DLP-D51 Set Up a Windows PC for Craft Connection to an ONS 15454 SDH Using Dynamic Host Configuration
Protocol
17-39
DLP-D52 Set Up a Windows PC for Craft Connection to an ONS 15454 SDH Using Automatic Host
Detection
17-42
DLP-D53 Set Up a Solaris Workstation for a Craft Connection to an ONS 15454 SDH 17-45
DLP-D54 Delete a Node from a Specified Login Node Group 17-47
DLP-D56 Disable Proxy Service Using Internet Explorer (Windows) 17-47
DLP-D57 Disable Proxy Service Using Netscape (Windows and UNIX) 17-48
DLP-D60 Log into CTC 17-49
DLP-D61 Create Login Node Groups 17-51
DLP-D62 Add a Node to the Current Session or Login Group 17-53
DLP-D64 Set the IP Address, Default Router, and Network Mask Using the LCD 17-53
DLP-D65 Create a Static Route 17-56
DLP-D67 Provision the IIOP Listener Port on the ONS 15454 SDH 17-57
DLP-D68 Provision the IIOP Listener Port on the CTC Computer 17-57
DLP-D69 Set Up External or Line Timing 17-58
DLP-D70 Set Up Internal Timing 17-61
DLP-D71 Create a 1:1 Protection Group 17-62
DLP-D72 Create a 1:N Protection Group 17-63
DLP-D73 Create a 1+1 Protection Group 17-64
DLP-D74 Create a New User on a Single Node 17-65
DLP-D75 Create a New User on Multiple Nodes 17-66
DLP-D76 Add a Member to a VCAT Circuit 17-67
DLP-D77 Delete a Member from a VCAT Circuit 17-69
DLP-D78 Install the TL1 Craft Interface on the MIC-C/T/P 17-70
DLP-D79 Remove Pass-through Connections 17-71
DLP-D80 Change a VCAT Member Service State 17-72
DLP-D81 Provision a Proxy Tunnel 17-73
DLP-D82 View Alarms 17-74
DLP-D83 Provision Orderwire 17-76
DLP-D84 Enable Node Security Mode 17-77