TASKS
iii
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
DLP-D1 Unpack and Verify the Shelf Assembly 17-1
DLP-D2 Inspect the Shelf Assembly 17-2
DLP-D3 Provision a Low-Order VC12 Circuit Route 17-2
DLP-D4 Create an IP-Encapsulated Tunnel 17-3
DLP-D5 Mount the Shelf Assembly in a Rack (One Person) 17-4
DLP-D6 Mount the Shelf Assembly in a Rack (Two People) 17-6
DLP-D7 Mount Multiple Shelf Assemblies in a Rack 17-7
DLP-D8 Open the Front Cabinet Compartment (Door) 17-9
DLP-D9 Remove the Front Door 17-10
DLP-D14 Create a Four-Fiber MS-SPRing Using the MS-SPRing Wizard 17-11
DLP-D16 Connect the Office Ground to the ONS 15454 SDH 17-13
DLP-D17 Connect Office Power to the ONS 15454 SDH Shelf 17-15
DLP-D18 Turn On and Verify Office Power 17-16
DLP-D22 Install Fiber-Optic Cables in a 1+1 Configuration 17-17
DLP-D23 View Spanning Tree Information 17-19
DLP-D24 Change an MS-SPRing Node ID 17-19
DLP-D25 Configure the CTC Alerts Dialog Box for Automatic Popup 17-20
DLP-D26 Provision a VCAT Circuit Route 17-20
DLP-D27 Delete Circuits 17-21
DLP-D28 Create a Four-Fiber MS-SPRing Manually 17-22
DLP-D29 Change Tunnel Type 17-24
DLP-D30 Repair an IP Tunnel 17-25
DLP-D31 Delete Overhead Circuits 17-25
DLP-D32 Inspect the Shelf Installation and Connections 17-26
DLP-D33 Measure Voltage 17-26
DLP-D34 Delete VLANs 17-27
DLP-D35 Delete a Node from the Current Session or Login Group 17-27
DLP-D36 Provision a VCAT Circuit Source and Destination 17-28
DLP-D37 Reset a TCC2/TCC2P Card Using CTC 17-29
DLP-D38 Reset a Traffic Card in CTC 17-30
DLP-D39 Install Ethernet Cards 17-30
To Next Page
Loading...
