Tasks
v
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
DLP-D82 View Alarms 17-74
DLP-D83 Provision Orderwire 17-76
DLP-D84 Enable Node Security Mode 17-77
DLP-D85 Lock Node Security 17-79
DLP-D86 Modify MIC-C/T/P Port IP Settings 17-79
DLP-D87 Disable Node Security Mode 17-80
DLP-D88 Optical 1+1 Protection Test 17-81
DLP-D89 Remap the K3 Byte 17-83
DLP-D90 Provision a Firewall Tunnel 17-83
DLP-D91 MS-SPRing Switch Test 17-84
DLP-D92 Four-Fiber MS-SPRing Exercise Span Test 17-88
DLP-D93 Four-Fiber MS-SPRing Span Switching Test 17-89
DLP-D94 SNCP Protection Switching Test 17-91
DLP-D95 Provision a Low-Order VC12 Circuit Source and Destination 17-93
DLP-D96 Provision a Low-Order VC3 Circuit Route 17-94
DLP-D97 Provision a High-Order Circuit Source and Destination 17-95
DLP-D98 Provision a High-Order Circuit Route 17-96
DLP-D99 Determine Available VLANs 17-98
DLP-D100 Delete a Proxy Tunnel 18-1
DLP-D101 Delete a Firewall Tunnel 18-1
DLP-D102 Hard-Reset a CE-100T-8 Card Using CTC 18-2
DLP-D103 Soft-Reset a CE100T-8 Card Using CTC 18-3
DLP-D104 Install the Fiber Clip on 15454_MRC-12 Cards 18-3
DLP-D105 Configure the Node for RADIUS Authentication 18-5
DLP-D106 View and Terminate Active Logins 18-7
DLP-D107 Preprovision an SFP or XFP Device 18-8
DLP-D108 Change Line Settings for STM-N Cards 18-9
DLP-D109 Change Optics Thresholds Settings for STM-64 and MRC-12 Cards 18-12
DLP-D111 Changing the Maximum Number of Session Entries for Alarm History 18-14
DLP-D112 Display Alarms and Conditions Using Time Zone 18-15
DLP-D113 Synchronize Alarms 18-15
DLP-D114 View Conditions 18-16
DLP-D117 Apply Alarm Profiles to Cards and Nodes 18-18
DLP-D121 Enable Pointer Justification Count Performance Monitoring 18-19
DLP-D122 Enable Intermediate Path Performance Monitoring 18-21
To Next Page
Loading...
