Cisco ONS 15454 SDH - Page 57

xvii
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
About this Guide
Chapter 7, “Manage Circuits” Includes procedures to view circuits and cross-connect resource
usage, modify and delete circuits and tunnels, convert and
upgrade CTC and TL1 circuits, monitor circuits, and create a J1
path trace.
Chapter 8, “Monitor Performance” Includes procedures to change the performance monitoring
(PM) display, monitor performance, and manage remote
monitoring (RMON) thresholds.
Chapter 9, “Manage Alarms” Includes procedures to document existing node data, view and
delete alarms, view alarm-affected circuits and LCD alarm
counts, manage alarm profiles, filter alarms, suppress alarms,
and provision external alarms.
Chapter 10, “Change Card Settings” Includes procedures to modify line settings and PM parameter
thresholds for cards, modify alarm interface controller settings,
and upgrade protection.
Chapter 11, “Change Node Settings” Includes procedures to change node management information,
CTC network access and view, and DWDM node settings;
change or delete card protection settings; delete SDH
regenerator section data communications channel (RS-DCC),
multiplex section data communications channel (MS-DCC),
generic communications channel (GCC), and DWDM optical
service channel (OSC) terminations; and change node timing,
security, and SNMP.
Chapter 12, “Upgrade Cards and
Spans”
Includes procedures to prevent an STM-N protection switch
during cross-connect upgrades, upgrade or downgrade cards,
and upgrade spans automatically or manually.
Chapter 13, “Convert Network
Configurations”
Includes procedures to convert network configurations, modify
an MS-SPRing, and manage MS-SPRing switches.
Chapter 14, “Add and Remove
Nodes”
Includes procedures to add and remove MS-SPRing, SNCP, or
linear nodes from a network configuration.
Chapter 15, “Maintain the Node” Includes procedures to inspect and manage the air filter, back
up and restore the database, restore the node to factory
configuration, off-load the security audit trail log, inhibit card
protection switching, revert software, clean fiber connectors,
reset the TCC2/TCC2P card using CTC, view Ethernet card
maintenance information, change the node timing reference,
and view the timing report.
Chapter 16, “Power Down the Node” Includes the procedure to power down the node.
Chapter 17, “DLPs D1 to D99” Includes all current tasks (DLPs) from D1 to D99.
Chapter 18, “DLPs D100 to D199” Includes all current tasks from D100 to D199.
Chapter 19, “DLPs D200 to D299” Includes all current tasks from D200 to D299.
Chapter 20, “DLPs D300 to D399” Includes all current tasks from D300 to D399.
Chapter 21, “DLPs D400 to D499” Includes all current tasks from D400 to D499.
Appendix A, “CTC Information and
Shortcuts”
Includes a description of the CTC views and window features.
Table 1 Cisco ONS 15454 SDH Procedure Guide Chapters (continued)
Title Summary