584 HEIDENHAIN Technical Manual iTNC 530 HSCI
9042 Read the spindle coordinates
(format = 0.001°)
949
9044 Read the spindle coordinates
(format = 0.0001°)
949
9045 Read the 3-D ROT data 764
9046
Copy controller data to the PLC memory
60642x-03 1096
9047 Reset or initialize controller algorithms 60642x-03 695
9048
Interrogate the operating states of axes
929
9050
Conversion from binary numbers
→
ASCII
1852
9051
Conversion from binary numbers
→
ASCII
1853
9052 Conversion from ASCII → binary 1854
9053 Conversion from ASCII → hexadecimal 1854
9054 Conversion from ASCII → hexadecimal
binary
1855
9055 Local time 1175
9060 M function status 1255
9061 Status of non-modal M functions 1255
9063 Collision monitoring, activating/
deactivating
1451
9064 Status of collision monitoring 1452
9065 Status of the commissioning function 1116
9066 Status of HEIDENHAIN supply unit 922
9066 Status of software settings 146
9070 Copy a number from a string 1828
9071 Find the string length 1829
9072 Copy a byte block into a string –
9073 Copy a string into a byte block –
9074 Load texts from error/dialog files into a
PLC string
1285
9075 Write to symbolic PLC operand 606 42x-02 1745
9076 Read symbolic PLC operand 606 42x-02 1746
9080 Clear the small PLC window 1355
9081 Interrogate the status of the small PLC
window
1355
9082 Display a string in the small PLC window 1356
9083 Display a moving-bar diagram in the small
PLC window
1357
9084 Display PLC error messages with
additional data
–
9085 Display PLC error message 1181
9086 Clear PLC error message 1181
9087 Status of PLC error message 1182
Module Function SW version Page
To Next Page
Loading...
