July 2013 5.1 Overview of modules 585
9088 Display the M functions 1158
9089 Control in operation 1159
9090 Select a line in the pallet table 1497
9091 Find the line number of a tool in the tool
table
1596
9092 Search for an entry in the tables selected
for execution (.T/.D/.TCH)
1572
9093 Read data from tables selected for
program run (.T/.D/.TCH)
1575
9094 Write data into a tool and datum table 1576
9095 Select active line in configuration file 657
9096 Delete a line from the tool table 1577
9097 Select the geometry description 732
9098 Find the active geometry description 731
9100 Assign data interface 1918
9101 Release data interface 1919
9102 Status of data interface 1919
9103 Transmit string through data interface 1920
9104 Receive string through data interface 1921
9105 Transmit binary data through data
interface
1922
9106
Receive binary data through data interface
1923
9107 Read from receiving buffer 1924
9110 Transmit a message via LSV2 1925
9111 Receive a message via LSV2 1926
9112
Transmit ASCII characters via data interface
1927
9113 Receive ASCII characters via data
interface
1928
9120 Start PLC axis 631
9121 Stop PLC axis 631
9122 Status of PLC axis 632
9123
Traverse the reference marks of PLC axes
633
9124 Feed rate override for PLC axis 634
9125 Stop PLC axis at next Hirth grid position 634
9128 Torque limiting by the PLC 878
9129 Status of torque limiting by the PLC 879
9130 Output of an analog voltage 1561
9132 Selection of override potentiometer 206
9133 Hardware information of the MC 42x(B) 904
907
9135 Switch on the 3-D touch probe 1538
Module Function SW version Page
To Next Page
Loading...
