8. Remove the Encoder disc and sensor on page 385.
9. Remove the
Substrate lever assembly on page 387.
10. Remove the SUBSTRATE INPUT??
11. Remove the
Static front platens (310) on page 382 — only for basic model.
12. Remove the
Static front platens (360) on page 380 — only for full model.
13. Remove one T-20 screw (Type B) that secures the cover on the right-hand side of the printer.
14. Remove the Cover.
15. Remove three T-20 screws that secure the cover on the left hand side of the printer.
ENWW Drive roller 241
To Next Page
Loading...
