9. To remove the right bracket:
●
Remove four T-15 screws on the left side.
●
Remove four T-15 screws and one T-25 screw on the right side.
If you stop here, the left bracket still holds the heater-controller enclosure, PCA isolator holder, and PCA
isolator. The PCA isolator is pre-pasted onto the left impinging bracket and the PCA isolator holder. The PCA
isolator is designed so that it can easily be divided. Leave the section already attached to the PCA isolator
holder (do not try to remove it, it is impossible). If the left impinging bracket is replaced, paste a new PCA
isolator to it, dividing it as needed.
Each bracket holds a shim. It needs to be moved to a new bracket if replaced. (This shim might be removed in
a couple of months.)
ENWW Impinging holding brackets 283
To Next Page
Loading...
