Label Explanation
Curing label. To identify the curing power cord.
Electric shock hazard. Heating modules operate at hazardous
voltages. Disconnect power source before servicing.
CAUTION: Double pole. Neutral fusing.
Equipment to be connected to earthed mains outlet only. Refer
servicing to qualified service personnel. Disconnect all power
cords before servicing. No operator serviceable parts inside the
printer.
Before starting, read and follow the operating and safety
instructions. Ensure that the input voltage is within the printer's
rated voltage range. The printer requires up to two dedicated
lines.
This label is located on the e-box.
Risk of burns. Do not touch the curing zone or the output platen
of the printer: they could be hot.
This label is located on the front of the curing module.
Risk of trapped fingers. Do not touch moving gears.
These labels are located at the rear of the printer, one on the
substrate input gear and one on the take-up reel gear (330 and
360 only).
Moving part. Keep away from the moving printhead carriage.
When printing, the printhead carriage travels back and forth
across the substrate.
This label is located on the rear of the scan axis window, behind
the plastic.
You are recommended to wear gloves when handling the
maintenance cartridge, the platen, or the ink collector.
This label is located on the maintenance cartridge.
Electric shock hazard. Heating modules operate at hazardous
voltages. Disconnect all power sources before servicing.
This label is located on the curing control PCA enclosure. For
service personnel only.
ENWW Warning labels 463
To Next Page
Loading...
Need help?
General
