Label Explanation
Electric shock hazard. The printer has two input power cords.
Power supplies operate at hazardous voltages. Disconnect all
power cords before servicing.
This label is located internally (in the 360 only), close to the print-
zone heating-coils enclosure between fans. For service personnel
only.
Hazardous moving parts. Rotating fan blades. Keep hands clear.
These labels are located internally, close to the print-zone
heating fans between fans (360 only), one near the vacuum fan
and one near the aerosol fan. For service personnel only.
Hazardous area. Heating modules operate at hazardous voltages.
Electric shock hazard. Equipment has two input power cords.
Disconnect all power cords before servicing. Power supplies
operate at hazardous voltages.
Double pole, neutral fusing.
Equipment to be connected to earthed mains outlet only.
This label is located in the scan and air-curtain heater control
enclosure (360 only). For service personnel only.
NOTE: The final label position and its size on the printer may vary slightly, but should always be visible and
close to the potential risk area.
464 Chapter 11 Safety precautions ENWW
To Next Page
Loading...
Need help?
General
