Diagnostic information 2-11
5062
202.33 Bin-full sensor is never made or is
made late.
1. Clear away anything in the paper path that might
cause the paper to jam.
2. If clearing a paper jam does not fix the problem,
go to “Pick arm stuck down service check”
on page 2-164.
202.34 Bin-full sensor broke early.
Possible causes:
• Incorrect paper settings
• Defective bin-full sensor
• Faulty system board
1. Clear away anything in the paper path that might
cause the paper to jam.
2. Be sure the paper settings match the media.
3. Go to “Pick arm stuck down service check”
on page 2-164.
202.35,
202.37
Bin-full sensor does not break or
breaks late.
• Incorrect paper settings
• Incorrect paper loaded
• Incorrect paper guide setting
• Bin-full sensor failure
1. Clear away anything in the paper path that might
cause the paper to jam.
2. Be sure the paper settings match the media.
3. Flex the media, and stack it flat in the paper tray.
4. Properly set the paper guides in the paper tray.
5. Check the pick roll tires, and replace them if they
are worn.
6. Go to “Pick arm stuck down service check”
on page 2-164.
202.38 Bin-full sensor is never made or is
made late.
See “202.33” on page 2-11.
202.39 Fuser motor stalled.
Possible causes:
• Faulty cable/connector
• Faulty fuser motor
• Faulty system board
1. Clear away anything in the paper path that might
cause the paper to jam.
2. If clearing a paper jam does not fix the problem,
go to “120.xx—Motor (fuser) error service
check” on page 2-68.
202.51 Exit sensor is made when the printer
tries to print from an idle state.
(Fuser past life)
See “202.01” on page 2-10.
202.52 Exit sensor is made early.
(Fuser past life)
See “202.02” on page 2-10.
202.53 Exit sensor is never made.
(Fuser past life)
See “202.03” on page 2-10.
202.54 Exit sensor broke early.
(Fuser past life)
See “202.04” on page 2-10.
202.55,
202.57
Exit sensor never broke.
(Fuser past life)
See “202.05, 202.07” on page 2-10.
202.58 Exit sensor is never made.
(Fuser past life)
See “202.03” on page 2-10.
203.01 Redrive bubble sensor is made when
the printer powers up or covers are
closed.
1. Clear away anything in the paper path that might
cause the paper to jam.
2. If clearing a paper jam does not fix the problem,
go to “Redrive bubble sensor service check”
on page 2-165
.
203.02 Paper hit the redrive bubble sensor
too soon.
Possible causes:
• Damaged redrive bubble sensor or
redrive bubble sensor flag
• Loose redrive bubble sensor
1. Clear away anything in the paper path that might
cause the paper to jam.
2. The redrive bubble sensor may not be
functioning properly. Go to “Redrive bubble
sensor service check” on page 2-165.
Error code Description Action
To Next Page
Loading...
Need help?
General
