Beta Draft Confidential
Configuring ATM Logical Ports on Frame-based Modules
Completing the Logical Port Configuration
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 1/19/054-53
After configuring the logical port(s):
• On a DTE logical port, you can add either an ATM OPTimum cell trunk logical
port or an ATM OPTimum frame trunk logical port.
• You can configure a trunk between two logical port endpoints for a trunk. See
Chapter 7, “Configuring Trunks,” for more information.
• You can add PVCs between logical port endpoints of an ATM UNI logical port
connection. See Chapter 10, “Configuring ATM PVCs,” for more information.
• You can configure logical ports on another physical port. Select the port, then see
the appropriate section in this chapter for the logical port type you want to
configure.
To Next Page
Loading...
