214 Rockwell Automation Publication 2198-UM004D-EN-P - December 2022
Chapter 9 Tuning
Tuning Mode 1 in KNX5100C Software
You can use KNX5100C software for manual tuning in Mode 1 by choosing
Manual Tuning from the Function List and selecting Mode 1.
Figure 90 - Selecting Mode 1 Manual Tuning
The Smoothing and Filtering tab lets you configure the parameters related to
the Low Pass and Moving filters and S-curve, depending upon your configured
Operating mode. See Chapter 10
for details on filters and s-curves.
To Next Page
Loading...
