Rockwell Automation Publication 2198-UM004D-EN-P - December 2022 187
Chapter 7 Configure the Drive with KNX5100C Software
Edit DIO Configurations
When Edit DIO Configurations is checked, the digital input (DI) and digital
output (DO) actual state is always Off. To change the function and status of DI
and DO signals, perform the following steps.
1. Check the box next to Edit DIO Configurations to enable the editing
function.
2. Use the pull-down menu to change the DIO function in the drive.
3. Click OK to save the changes and write to the drive.
4. When you have configured all your I/O, clear the Edit DIO
Configurations checkbox.
To Next Page
Loading...
Need help?
General
