122 Rockwell Automation Publication 2198-UM004D-EN-P - December 2022
Chapter 6 Use the Keypad Interface
Edit Settings From the
Display
Access the Setting display from the Drive Status display by pressing the
key.
When the drive is disabled/servo off, perform the following steps.
1. Press the key to enter the editing mode.
Use the keys to scroll through the Network setting, reset, and
parameter setting displays.
2. Press the key to return to the previous display.
Figure 74 - State Switch Machine of Information Display and Setup
Edit Network Settings
From the Setting display, perform the following steps.
1. Press to go to Network Setting display.
2. Press again to enter the Static IP display.
From that display, there are two choices:
• Press again to set a static IP address. See Set Static IP Address
.
• Press to turn DHCP on or off. See Turn DCHP On or Off
on
page 123.
Set Static IP Address
On the Static IP Address display, perform the following steps.
1. Press the key to enter the IP Setting display.
2. Press the key to enter the edit display.
3. Use the keys to move between the IP Address, Gateway, and Subnet
setting screens.
See Figure 75
.
4. Press in any one of those settings displays and use the keys to
edit the values.
5. Press the key twice to set the values and return to the original display.
Drive
Status
Setting
Version
Information
Device
Information
Information Display/Setup
To Next Page
Loading...
Need help?
General
