Rockwell Automation Publication 2198-UM004D-EN-P - December 2022 225
Chapter 9 Tuning
Manual Mode Tuning in KNX5100C Software
You can use KNX5100C software for manual mode tuning by choosing
Function List>Tuning>Manual Tuning.
Figure 93 - Selecting Manual Mode Tuning
The Smoothing and Filtering tab lets you configure the parameters related to
the Low Pass and Moving filters and S-curve, depending upon your configured
Operating mode. See Chapter 10
for details on filters and S-curves.
To Next Page
Loading...
