Rohde & Schwarz R&S ZNA Series - Page 1793

Annexes
R&S
®
ZNA
1793User Manual 1178.6462.02 ─ 29
ENA Emulation Command R&S ZNA Default Parser Command
SENSe{1...4}:CORRection:COLLect:
METHod[:RESPonse]:OPEN <numeric>
SENSe{1...4}:CORRection:COLLect:
METHod[:RESPonse]:SHORt <numeric>
SENSe{1...4}:CORRection:COLLect:
METHod:SOLT1 <numeric>
SENSe{1...4}:CORRection:COLLect:
METHod:SOLT2 <numeric1>, <numeric2>
SENSe{1...4}:CORRection:COLLect:
METHod:SOLT3 <numeric1>, <numeric2>,
<numeric3>
SENSe{1...4}:CORRection:COLLect:
METHod:SOLT4 1,2,3,4
SENSe{1...4}:CORRection:COLLect:
METHod[:RESPonse]:THRU <numeric1>,
<numeric2>
SENSe{1...4}:CORRection:COLLect:
METHod:TYPE?
SENSe{1...4}:CORRection:TYPE{1...4}?
[SENSe<Ch>:]CORRection:COLLect:METHod:
DEFine
SENSe{1...4}:CORRection:COLLect:SAVE
[SENSe<Ch>:]CORRection:COLLect:SAVE[:
DUMMy]
SENSe{1..4}:CORRection:COLLect:UTHRu[:
STATe] {OFF | 0}
SENSe<Ch>:CORRection:EXTension[:STATe]
{ON | OFF | 1 | 0}
[SENSe<Ch>:]CORRection:OFFSet<PhyPt>:
COMPensation[:STATe]
SENSe{1...4}:CORRection:EXTension:
PORT{[1]|2 | 3|4}:TIME <numeric>
[SENSe<Ch>:]CORRection:EDELay<PhyPt>[:
TIME]
SENSe{1...4}:CORRection:STATe {ON |
OFF | 1 | 0}
[SENSe<Ch>:]CORRection[:STATe]
SENSe{1...4}:FREQuency:CENTer
<numeric>
[SENSe<Ch>:]FREQuency:CENTer
SENSe{1...4}:FREQuency:DATA?
CALCulate<Chn>:DATA:STIMulus?
SENSe{1...4}:FREQuency:SPAN <numeric>
[SENSe<Ch>:]FREQuency:SPAN
SENSe{1...4}:FREQuency:STARt <numeric>
[SENSe<Ch>:]FREQuency:STARt
SENSe{1...4}:FREQuency:STOP <numeric>
[SENSe<Ch>:]FREQuency:STOP
SENSe{1...4}:ROSCillator:SOURce?
[SENSe<Ch>:]ROSCillator[:SOURce]
SENSe{1...4}:SEGMent:SWEep:POINts?
[SENSe<Ch>:]SEGMent<Seg>:SWEep:POINts
SENSe{1...4}:SEGMent:SWEep:TIME?
[SENSe<Ch>:]SEGMent<Seg>:SWEep:TIME
SENSe{1...4}:SEGMent:DATA 5,<mode>,
<ifbw>, <pow>, <del>, <time>, <segm>,
<star 1>, <stop 1>, <nop 1>, <ifbw 1>,
<pow 1>, <del 1>, <time 1>,...,
SENSe{1...4}:SWEep:DELay <numeric>
[SENSe<Ch>:]SWEep:DWELl
ENA emulation commands