AudioCodes Mediant MSBR Series User Manual

Reference Guide 476 Document #: LTRT-17939
Mediant MSBR
Command Description
retry-aftr-time
Retry After time for the proxy to be in state Unavailable.
rfc4117-trnsc-enbl
Enables transcoding call.
rport-support
Enables Rport option in Via header.
rtcp-attribute
Enables RCTP attribute in the SDP.
rtcp-xr-coll-srvr
Defines the RTCP-XR server IP address.
rtcp-xr-rep-mode
0:rtcpxr is not sent over SIP at all{@}1:rtcpxr is sent over
sip when call ended{@}2:rtcpxr is sent over sip when on
periodic interval and when call ended{@}3:rtcpxr is sent
over sip when media segment ended and when call ended
rtcpxr-collect-serv-
transport
Defines the RtcpXrEsc transport type.
rtp-only-mode
On RTP only mode there is no signaling protocol (for
media parameters negotiation with the remote side). The
channel is open immediately. 0 - regular call
establishment. 1 - The RTP channel open for Rx & Tx. 2-
The RTP channel open only for Tx 3 -The RTP channel
open only for Rx
rtp-rdcy-nego-enbl
Enables RTP Redundancy negotiation.
sbc-rtcpxr-report-mode
0:rtcpxr is not sent over SIP at all,1:rtcpxr is sent over sip
when call ended
sdp-ecan-frmt
Defines echo canceller format for outgoing SDP.
sdp-session-owner
Defines the SDP owner string.
sdp-ver-nego
Handle SDP offer/answer if SDP version was increased,
otherwise takes SDP offer/answer parameters from last
agreement (derived from previous SDP negotiations).
sec-call-src
Defines from where the second calling number is taken
from (in an incoming INVITE request).
self-check-audit
Defines if resources self-check audit is used.
send-180-for-call-
waiting
Sends 180 for call waiting.
sess-exp-disc-time
Defines the minimum time factor before the session
expires.
sig-cpu-usage-
threshold
Defines the signaling cpu usage threshold alarm
(percentage)
silk-max-avg-bitrate
Defines the Silk max average bitrate (bps).
single-dsp-transcoding
Enables single DSP for G.711 to LBR coder.
sip-dst-port
Defines the default SIP destination port (usually 5060).
sip-hold-behavior
if set to 1, handle re-INVITE with a=recvonly as a=inactive
sip-max-rtx
Defines the maximum number of retransmissions.
sip-nat-detect
If not set, the incoming request will be always processed
as user NOT behind NAT
sip-remote-reset
Enables remote management of device by receiving
NOTIFY request with specific event type.

AudioCodes Mediant MSBR Series Specifications

General

Brand	AudioCodes
Model	Mediant MSBR Series
Category	Network Router
Language	English