EasyManua.ls Logo

Cisco ONS 15454 SDH - Page 14

Cisco ONS 15454 SDH
860 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Contents
xiv
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
DLP- D180 Edit the OSI Subnetwork Point of Attachment 18-68
DLP- D181 Edit an IP-Over-CLNS Tunnel 18-69
DLP- D182 Delete an IP-Over-CLNS Tunnel 18-70
DLP- D183 View IS-IS Routing Information Base 18-70
DLP- D184 View ES-IS Routing Information Base 18-71
DLP- D185 Manage the TARP Data Cache 18-72
DLP- D186 Provision a Low-Order VC11 Circuit Source and Destination 18-73
DLP- D187 Provision a Low-Order VC11 Circuit Route 18-74
DLP- D188 View CE-Series Ethernet and POS Ports Statistics PM Parameters 18-75
DLP- D189 Verify that a 1+1 Working Slot is Active 18-77
DLP- D190 View CE-Series Ethernet and POS Ports Utilization PM Parameters 18-78
DLP- D191 Delete a Card 18-79
DLP- D192 View CE-Series Ethernet and POS Ports History PM Parameters 18-80
DLP- D193 Grant Superuser Privileges to a Provisioning User 18-81
DLP- D194 Clear an MS-SPRing Force Ring Switch 18-82
DLP- D195 Verify Timing in a Reduced Ring 18-82
DLP- D196 Delete an MS-SPRing from a Single Node 18-83
DLP- D197 Initiate an SNCP Force Switch 18-84
DLP- D198 Clear an SNCP Force Switch 18-85
CHAPTER
19 DLPs D200 to D299 19-1
DLP- D201 Apply a Lock-On 19-1
DLP- D202 Apply a Lockout 19-2
DLP- D203 Clear a Lock-On or Lockout 19-3
DLP- D204 Clean Multi Fiber-Optic Cable Connectors 19-3
DLP- D205 Clean Fiber Connectors with CLETOP 19-4
DLP- D206 Clean the Fiber Adapters 19-4
DLP- D207 Delete a Server Trail 19-5
DLP- D208 Change External Alarms Using the AIC-I Card 19-5
DLP- D209 Change External Controls Using the AIC-I Card 19-6
DLP- D210 Change AIC-I Card Orderwire Settings 19-7
DLP- D211 Provision CE-1000-4 Ethernet Ports 19-8
DLP- D212 Create a User Data Channel Circuit 19-9
DLP- D214 Change the Service State for a Port 19-10
DLP- D215 Consolidate Links in Network View 19-11
DLP- D216 Change the STM-N Card ALS Maintenance Settings 19-14
DLP- D217 MS-SPRing Exercise Ring Test 19-15
DLP- D218 Provision SNCP Ring Selectors During Circuit Creation 19-17
DLP- D219 Provision a Low-Order Tunnel Route 19-18
DLP- D220 Provision E-Series Ethernet Ports 19-18

Table of Contents

Other manuals for Cisco ONS 15454 SDH

Related product manuals