Cisco ONS 15454 SDH - Page 15

Contents
xv
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
DLP- D221 Provision E-Series Ethernet Ports for VLAN Membership 19-19
DLP- D222 Provision G-Series Ethernet Ports 19-21
DLP- D223 Download an Alarm Severity Profile 19-22
DLP- D224 Adjust the Java Virtual Memory Heap Size 19-23
DLP- D225 Enable Alarm Filtering 19-24
DLP- D227 Disable Alarm Filtering 19-25
DLP- D229 View Circuits on a Span 19-25
DLP- D230 Change a Circuit State 19-26
DLP- D231 Edit a Circuit Name 19-27
DLP- D232 Change Active and Standby Span Color 19-28
DLP- D233 Edit SNCP Circuit Path Selectors 19-29
DLP- D234 Roll the Source or Destination of One Optical Circuit 19-30
DLP- D235 Roll One Cross-Connect from an Optical Circuit to a Second Optical Circuit 19-33
DLP- D236 Roll Two Cross-Connects on One Optical Circuit Using Automatic Routing 19-35
DLP- D237 Roll Two Cross-Connects on One Optical Circuit Using Manual Routing 19-39
DLP- D238 Roll Two Cross-Connects from One Optical Circuit to a Second Optical Circuit 19-41
DLP- D239 Delete a Roll 19-43
DLP- D240 Cancel a Roll 19-43
DLP- D241 Clear an MS-SPRing Manual Ring Switch 19-44
DLP- D242 Create an MS-SPRing on a Single Node 19-45
DLP- D243 Create a VLAN 19-46
DLP- D244 Use the Reinitialization Tool to Clear the Database and Upload Software
(Windows) 19-47
DLP- D245 Use the Reinitialization Tool to Clear the Database and Upload Software (UNIX) 19-49
DLP- D246 Provision E-Series Ethernet Card Mode 19-50
DLP- D247 Change an STM-N Card 19-51
DLP- D248 Delete VLANs 19-52
DLP- D249 Provision IP Settings 19-52
DLP- D250 Set Up or Change Open Shortest Path First Protocol 19-56
DLP- D251 Set Up or Change Routing Information Protocol 19-58
DLP- D254 TCC2/TCC2P Card Active/Standby Switch Test 19-59
DLP- D255 Cross-Connect Card Side Switch Test 19-60
DLP- D256 View Ethernet Statistics PM Parameters 19-61
DLP- D257 View Ethernet Utilization PM Parameters 19-62
DLP- D258 View Ethernet History PM Parameters 19-63
DLP- D259 Refresh Ethernet PM Counts at a Different Time Interval 19-63
DLP- D260 Set Auto-Refresh Interval for Displayed PM Counts 19-64
DLP- D261 Refresh PM Counts for a Different Port 19-65
DLP- D262 Filter the Display of Circuits 19-65
DLP- D263 Edit SNCP Dual-Ring Interconnect Circuit Hold-Off Timer 19-67