Cisco ONS 15454 SDH - Page 16

Contents
xvi
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
DLP- D264 Provision a J1 Path Trace on Circuit Source and Destination Ports 19-68
DLP- D265 Change the Login Legal Disclaimer 19-71
DLP- D266 Change IP Settings 19-72
DLP- D268 Apply a Custom Network View Background Map 19-73
DLP- D269 Enable Dialog Box Do-Not-Display Option 19-74
DLP- D271 Change Node Security Policy on a Single Node 19-74
DLP- D272 Change Node Security Policy on Multiple Nodes 19-76
DLP- D273 Modify SNMP Trap Destination 19-77
DLP- D293 Perform a Manual Span Upgrade on a Two-Fiber MS-SPRing 19-78
DLP- D294 Perform a Manual Span Upgrade on a Four-Fiber MS-SPRing 19-79
DLP- D295 Perform a Manual Span Upgrade on an SNCP 19-80
DLP- D296 Perform a Manual Span Upgrade on a 1+1 Protection Group 19-81
DLP- D297 Perform a Manual Span Upgrade on an Unprotected Span 19-82
DLP- D298 Check the Network for Alarms and Conditions 19-83
DLP- D299 Initiate an MS-SPRing Span Lockout 19-84
CHAPTER 20 DLPs D300 to D399 20-1
DLP- D300 Clear an MS-SPRing Span Lockout 20-1
DLP- D301 Initiate an MS-SPRing Manual Ring Switch 20-2
DLP- D303 Initiate an MS-SPRing Force Ring Switch 20-3
DLP- D309 View Ethernet MAC Address Table 20-4
DLP- D310 View Ethernet Trunk Utilization 20-5
DLP- D311 Provision a Half Circuit Source and Destination on an MS-SPRing or 1+1 Node 20-5
DLP- D312 Provision a Half Circuit Source and Destination on an SNCP Ring 20-6
DLP- D314 Assign a Name to a Port 20-7
DLP- D315 Log Out a User on a Single Node 20-7
DLP- D316 Log Out a User on Multiple Nodes 20-8
DLP- D318 Provision a Low-Order VC3 Circuit Source and Destination 20-9
DLP- D321 Open the FMEC Cover 20-10
DLP- D322 Remove the FMEC Cover 20-11
DLP- D324 Install Alarm Cables on the MIC-A/P 20-12
DLP- D325 Install Timing Cables on the MIC-C/T/P 20-15
DLP- D326 Install LAN Wires on the MIC-C/T/P 20-16
DLP- D328 Install 75-Ohm E-1, E-3, or STM-1 Coaxial Cables 20-17
DLP- D329 Install 120-Ohm E-1 Cables with DB-37 Connectors to the FMECs 20-18
DLP- D330 Install 120-Ohm E-1 Cables with Molex 96-Pin LFH Connectors 20-20
DLP- D332 Install the TCC2/TCC2P Cards 20-22
DLP- D333 Install the XC-VXL-10G, XC-VXL-2.5G, or XC-VXC-10G Cards 20-25
DLP- D334 Install the Alarm Interface Controller–International Card 20-26
DLP- D335 Install GBIC or SFP/XFP Devices 20-28