Cisco ONS 15454 SDH - Perform an XC Loopback on a Destination-Node STM-N VC (West to East) Carrying an Electrical Signal

Contents
xvii
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
DLP- D336 Remove GBIC or SFP/XFP Device 20-32
DLP- D337 Install Fiber-Optic Cables for SNCP Configurations 20-33
DLP- D338 Install Fiber-Optic Cables for MS-SPRing Configurations 20-37
DLP- D365 Change Line and Threshold Settings for E1-N-14 or E1-42 Cards 20-39
DLP- D340 Change Line and Threshold Settings for the E3-12 Cards 20-43
DLP- D341 Change Line and Threshold Settings for the DS3i-N-12 Cards 20-47
DLP- D342 Change Line and Threshold Settings for the STM1E-12 Card 20-51
DLP- D343 Change SDH Threshold Settings for STM-N Cards 20-54
DLP- D348 View ML-Series Ether Ports PM Parameters 20-56
DLP- D349 View ML-Series POS Ports PM Parameters 20-57
DLP- D353 Provision G-Series Flow Control Watermarks 20-58
DLP- D354 Change General Port Settings for the FC_MR-4 Card 20-59
DLP- D355 Change Distance Extension Port Settings for the FC_MR-4 Card 20-61
DLP- D356 Change Enhanced FC/FICON Port Settings for the FC_MR-4 Card 20-63
DLP- D357 Verify Pass-Through Circuits 20-64
DLP- D358 Change a Multiplex-Section DCC Termination 20-65
DLP- D359 Change a Regenerator-Section DCC Termination 20-65
DLP- D360 Delete a Regenerator-Section DCC Termination 20-66
DLP- D361 Create a DCC Tunnel 20-66
DLP- D362 Delete a Multiplex-Section DCC Termination 20-68
DLP- D363 Provision Regenerator-Section DCC Terminations 20-68
DLP- D364 Provision Multiplex-Section DCC Terminations 20-71
DLP- D367 Provision a J2 Path Trace on Circuit Source and Destination Ports 20-72
DLP- D368 Manual or Force Switch the Node Timing Reference 20-75
DLP- D369 Clear a Manual or Force Switched Node Timing Reference 20-76
DLP- D370 View Circuit Information 20-76
DLP- D371 View the MS-SPRing Squelch Table 20-80
DLP- D372 Import a Cisco MetroPlanner Configuration File 20-81
DLP- D388 Verify MS-SPRing Extension Byte Mapping 20-81
DLP- D393 Switch Between TDM and DWDM Network Views 20-82
CHAPTER 21 DLPs D400 to D499 21-1
DLP- D420 Install the Public-Key Security Certificate 21-1
DLP- D421 View STM-N PM Parameters 21-2
DLP- D422 Change the JRE Version 21-4
DLP- D424 View Alarm or Event History 21-4
DLP- D425 Create a New or Cloned Alarm Severity Profile 21-6
DLP- D426 Apply Alarm Profiles to Ports 21-9
DLP- D427 Delete Alarm Severity Profiles 21-11
DLP- D428 Modify Alarm, Condition, and History Filtering Parameters 21-12