Cisco ONS 15454 SDH - Page 695

20-11
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D322 Remove the FMEC Cover
Figure 20-3 Unscrewing the FMEC Cover
Step 2
Use the handles to pull the cover forward.
Step 3 Return to your originating procedure (NTP).
DLP-D322 Remove the FMEC Cover
Step 1 Unscrew the nut holding the ground wire to the shelf. Remove the nut and washer.
Step 2 Remove the ground wire from the left side of the shelf.
Step 3 Pull the right side of the hinge-locking spring (Figure 20-4).
Purpose This task removes the FMEC cover.
Tools/Equipment Medium slot-head screwdriver
Prerequisite Procedures DLP-D321 Open the FMEC Cover, page 20-10
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
71086
CISCO ONS 15454
Optical Network System
F
A
N
F
A
IL
C
R
IT
M
A
J
M
IN
Screws