6-79
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 6 Create Circuits and Low-Order Tunnels
NTP- D142 Create an E-Series Shared Packet Ring Ethernet Circuit
Tip You can also add VLANs in network view by choosing Tools > Manage VLANs. In the
All VLANs dialog box, click the Create button to open the Define New VLAN dialog box.
Step 18 In the Available VLANs column, click the VLAN you want to use and click the arrow button (>>) to
move the VLAN to the Circuit VLANs column.
Note Moving the VLAN from Available VLANs to Circuit VLANs forces all the VLAN traffic to use
the shared packet ring you are creating.
Step 19 Click Next.
Step 20 In the Circuit Routing Preferences area, uncheck the Route Automatically check box and click Next.
Step 21 In the Route Review and Edit area, click the source node, then click a span (green arrow) leading away
from the source node.
The span turns white.
Step 22 Click Add Span.
The span turns blue. CTC adds the span to the Included Spans list.
Step 23 Click the node at the end of the blue span.
Step 24 Click the green span attached to the node you clicked in Step 23.
The span turns white.
Step 25 Click Add Span.
The span turns blue.
Step 26 Repeat Steps 23 through 25 for every node in the ring.
Step 27 Verify that the new circuit is correctly configured in the Route Review and Edit area. If the circuit
information is not correct, click the Back button and repeat the procedure with the correct information.
Note If the circuit is incorrect, you can also click Finish, delete the completed circuit, and begin the
procedure again.
Step 28 Click Finish.
Step 29 Complete the “DLP-D220 Provision E-Series Ethernet Ports” task on page 19-18 for each node that
carries the circuit.
Step 30 Complete the “DLP-D221 Provision E-Series Ethernet Ports for VLAN Membership” task on
page 19-19 for each node that carries the circuit.
Step 31 Complete the “NTP-D146 Test E-Series Circuits” procedure on page 6-89.
Stop. You have completed this procedure.
To Next Page
Loading...
