Cisco ONS 15454 SDH - Page 261

6-87
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 6 Create Circuits and Low-Order Tunnels
NTP- D145 Create an E-Series Multicard EtherSwitch Manual Cross-Connect
b. In the New VLAN dialog box, complete the following:
• VLAN Name—Assign an easily identifiable name to your VLAN.
• VLAN ID—Assign a VLAN ID. The VLAN ID should be the next available number between 2
and 4093 that is not already assigned to an existing VLAN. Each ONS 15454 SDH network
supports a maximum of 509 user-provisionable VLANs.
• Topology Host—Choose the topology host ID from the drop-down list.
c. Click OK.
Tip You can also add VLANs in network view by choosing Tools > Manage VLANs. In the
All VLANs dialog box, click the Create button to open the Define New VLAN dialog box.
Step 18 In the Available VLANs column, click the VLAN you want to use and click the arrow button (>>) to
move the VLAN to the Circuit VLANs column.
Step 19 Click Next.
The Circuit Creation (Circuit Routing Preferences) dialog box appears.
Step 20 Verify the cross-connect information (in this step, “circuit” refers to the Ethernet cross-connect):
• Circuit name
• Circuit type
• Circuit size
• VLANs
• ONS 15454 SDH nodes
If the information is not correct, click the Back button and repeat the procedure with the correct
information. If the information is correct, check Route Automatically.
Step 21 Click Finish.
Step 22 Complete the “DLP-D220 Provision E-Series Ethernet Ports” task on page 19-18.
Step 23 Complete the “DLP-D221 Provision E-Series Ethernet Ports for VLAN Membership” task on
page 19-19.
Step 24 From the View menu, choose Go to Home View.
Step 25 Click the Circuits tab.
Step 26 Highlight the circuit and click Edit.
The Edit Circuit dialog box appears.
Step 27 Click Drops and click Create.
The Define New Drop dialog box appears.
Step 28 From the Slot drop-down list, choose the STM-N card that links the ONS 15454 SDH to the
non-ONS 15454 SDH equipment.
Step 29 From the Port drop-down list, choose the appropriate port.
Step 30 From theVC4 drop-down list, choose the VC4 that matches the VC4 of the connecting
non-ONS 15454 SDH equipment.
Step 31 Click OK.
Step 32 Confirm the circuit information appears in the Edit Circuit dialog box and click Close.